Toa N-8000 Series Ver.1.41 - Manual (Page 76)

2-24
Chapter 2: FUNCTIONS AND OPERATION
3.1.2. Selectable paging
Paging calls can be made to up to 10 zones.
Use the supplied N-8000 Software program to set the paging zones. (Refer to
p.5-61 .)
Step 1. Press the Paging key, then [ ] key followed by the desired paging zone number (1 – 160).
Note
Enter a zone number with the same digit length (1 – 3 digits) set with the N-8000 Software program.
Step 2. To select the zone numbers consecutively, press the [ ] key.
Step 3. To terminate the zone selection, press the [ ] key following the zone number.
A paging tone is sounded in the selected zone(s).
Step 4. Page with the handset either lifted or in place.
Note
If the system's paging response mode has been set to designate the zone number (Refer to
p. 2-28 .),
notify the paged party of the response zone number (any one of the paged zones) in the paging
message.
Step 5. Either press the Clear key or replace the handset.
The paging is completed.
Zone 1
Amplifier
Speaker
No. 1000 No. 1002 No. 1003 No. 1004
Zone 23
No. 2000
Zone 105
Amplifier
Speaker
or
1~3
5
4
0 0 1
0 2
1
C
0 5
3
or
(Zone number with 3-digit length)
[Example paging to the zone 1, 23 and 105.]