Function settings, P. 5-30, Refer to – Toa N-8000 Series Ver.1.41 User Manual
Page 174: Transfer start/end time. (refer to, Units). (refer to, 8000 software. (refer to
5-30
Chapter 5: SYSTEM SETTINGS BY SOFTWARE
Chapter 5: SYSTEM SETTINGS BY SOFTWARE
Exchange: Function Settings
5.4.3. Function settings
Step 1. Click "Function Settings" tab to display the following setting screen.
Step 2. Set individual items.
(1) Transfer settings
Set the transfer function ON or OFF for the station connected to the exchange.
Call forwarding:
Calls to stations are automatically transferred to another designated
station without sounding a call tone only when Call forwarding function is
enabled.
Time-based call forwarding: Calls to stations are automatically transferred to another designated
station without sounding a call tone only when the preset time is reached.
This function can be set only when the call forwarding function is enabled.
Preset time can be set only when the time-based call forwarding function is
enabled.
Group hunting:
Calls to a busy station are automatically transferred to another designated
station, if group hunting function is set to the called station.
Absence transfer:
When no response is made to a call to the station for a set period of time,
the call is automatically transferred to another designated station. Preset
time duration can be set only when the absence transfer mode is enabled.
(2) Oneshot make time (second)
Sets the duration that the external control output terminals are shorted momentarily when the door remote
control function is performed.
The setting range is from 0 to 9 (in 1-second units).
If not required, set the duration to "0."