Toa N-8000 Series Ver.1.41 - Manual (Page 68)

2-16
Chapter 2: FUNCTIONS AND OPERATION
2.7.2. Absence transfer
When no response is made to a call to the station for a set period of time, the call is automatically transferred
to another designated station.
Calls received during conversation can be transferred. (Refer to
p. 2-12 .)
The station to which a Absence transfer is to be transferred can be set either by a dialing operation (see
below) or using the supplied N-8000 Software program. (Refer to
p. 5-52 , 5-56 .)
Use the supplied N-8000 Software program to enable or disable the Absence transfer or to set a calling
duration. (Refer to
p. 5-30 , 5-49 .)
The station to which a call is to be transferred cannot be designated unless the Call forwarding function is
enabled.
Notes
Calls are not transferred under the following conditions:
• The designated station is set for Call forwarding.
• The designated station is not in standby mode
• The station set for Absence transfer is called as a representative or its associated member station of the
group.
Call
A call is automatically
transferred to another
designated station after
a set period of time
Call tone
No. 62
No. 11
Call tone
The designated transfer
destination station
No. 63
6 2
Programming or erasure can be performed at your station.
[Programming] 4 4 X X + + + (Confirmation tone)
Function designation
number
Transfer destination
station number
[Erasure] 4 4 Y Y + + + (Confirmation tone)
The originally called (your) station number
Notes
• The station to which a call is to be transferred via multi interface unit cannot be programmed as a
transfer destination station.
• The programmed contents by dialing operation are automatically saved into the exchange or IP
stations at midnight every day. If the exchange or IP station is turned off before completion of save,
the state returns to the contents that were programmed before power-off.