Toa N-8000 Series Ver.1.41 - Manual (Page 81)

2-29
Chapter 2: FUNCTIONS AND OPERATION
4. OTHER FUNCTIONS AND OPERATION
4.1. Scan Monitor
The station can scan an arbitrary group of pre-programmed stations for auditory monitoring.
Stations are monitored in preprogrammed sequence at specified time intervals.
Manual control from the monitoring station can also be performed.
Up to 16 stations can be programmed to the same monitor group.
Up to 4 station groups (up to 64 stations) can be monitored in sequence from a single station.
• Use the supplied N-8000 Software program to set a monitor group or scan monitor duration. (Refer to p. 5-55 ,
p. 5-60 .)
• Stations not in standby mode are skipped and not monitored.
• The status indicator on the monitored station remains in standby mode and unchanged.
[Operation]
Step 1. Automatic Scan
Press the [ ] and [2] keys, and after dialing the monitor group number (1 – 4), press the [ ]
key.
When monitoring two or more groups, dial the group numbers consecutively.
• Scan monitoring is started and cycles through the station groups in preprogrammed sequence and
at specified time intervals until its operation is manually stopped.
• Both the number and name of the station being monitored are displayed on the monitoring station's
liquid crystal display. (N-8000MS/8500MS only)
[Example] Station No. 331 is being monitored.
• A handset can also be used for monitoring.
3 3 1 e l e v a t o r 3 F Station No. Station name
No. 330 No. 331 No. 332 No. 339
Scan monitor group
Manual scan
: Stop/Restart
: Advances the scan
: Moves the scan back
: A voice warning
to the monitored station
Monitor scan
Monitor group number
PTT
0
Press
replace the handset: Scan monitor end
C
X 2
or