Toa N-8000 Series Ver.1.41 - Manual (Page 62)

2-10
Chapter 2: FUNCTIONS AND OPERATION
2.4.2. One-touch dialing
The dial operation (up to 20-digit numbers) programmed
into the station's [7], [8], [9], [0], or [Off-Hook*] keys can be
called by one-touch dialing.
* The action to lift up the handset.
Notes
• Perform one-touch dial programming when using the
external dial input terminal on the N-8031MS.
• The one-touch programming can be performed either by dialing operation (see below) or using the supplied
N-8000 Software program. (Refer to p. 5-54 , 5-59 .)
Call No. 200
8
6 X Y Y PTT + + + + (Confirmation tone)
Function
designation No.
dial to be programmed
(up to 20 digits)
One-touch
dialing key
6 X PTT + + + (Confirmation tone)
6 7 4 + + + + 1 + PTT +
Function
designation No. dial to be programmed
(Example) Function designation number of Call forwarding
One-touch
dialing key
6 PTT 1 3 PTT + + + 2 + + +
Function
designation No. dial to be programmed
One-touch
dialing key
6 PTT PTT + + +
Function
designation No.
One-touch
dialing key
[Programming]
[Erasure]
Tips
• The key X above represents the [7], [8], [9], [0], or Push-to-talk keys, which are used for one-touch
functions.
• Enter one-touch dialing programming (the key Y above) using the Dial keys (12), Paging key, Paging
response key, Hold key, and/or Function key.
[Example] Programming [7] key for function designation number of Call forwarding.
• Press the Push-to-talk key when enabling the Off-Hook function for one-touch key operation.
[Example] Programming and erasing of station [1][2][3] for the Off-Hook function.
[Programming]
[Erasure]
Note
The programmed contents by dialing operation are automatically saved into the exchange or IP
stations at midnight every day. If the exchange or IP station is turned off before completion of save,
the state returns to the contents that were programmed before power-off.