Toa N-8000 Series Ver.1.41 - Manual (Page 69)

2-17
Chapter 2: FUNCTIONS AND OPERATION
2.7.3. Call forwarding
Calls to stations are automatically transferred to another designated station without sounding a call tone.
Two different modes are available: one is call forwarding, in which calls are manually rerouted to the selected
station, and the other is time-based call forwarding, which transfer calls only when the preset time is reached.
This Call forwarding function also applies to the call transfer (
p. 2-12 ) performed during conversation.
The station to which a Call forwarding is to be transferred can be set either by dialing operation (see below
and
p. 2-18 ) or using the supplied N-8000 Software program. (Refer to p. 5-52 , 5-56 .)
Use the supplied N-8000 Software program to enable or disable the Call forwarding function or to set the
transfer start/end time. (Refer to
p. 5-30 , 5-49 .)
The station to which a call is to be transferred cannot be designated unless the Call forwarding function is
enabled.
Note
Calls are not transferred if the station set for Call forwarding is called as an associated member station of the
group.
[Calls to stations manually set for call forwarding]
Calls to the station manually set for Call
forwarding are automatically transferred to
the designated station without sounding a
call tone.
No. 61
Number 62
(The originally called
station, which has been
set to the Call forwarding mode)
No. 63
(The designated transfer destination station)
6 2
Call tone
Programming can be performed at your station or the transfer destination station, while erasure at your
station.
[Programming at your station] 4 1 X X + + + (Confirmation tone)
Function designation
number
Transfer destination
station number
[Erasure]
(available only at your station)
4 1 Y Y + + + (Confirmation tone)
The originally called (your) station number
[Programming at the transfer
destination station] 4 2 Y Y + + + (Confirmation tone)
The originally called (your) station number
Notes
• The station to which a call is to be transferred via multi interface unit cannot be programmed as a
transfer destination station.
• The programmed contents by dialing operation are automatically saved into the exchange or IP
stations at midnight every day. If the exchange or IP station is turned off before completion of save, the
state returns to the contents that were programmed before power-off.