Toa N-8000 Series Ver.1.41 - Manual (Page 47)

1-34
Chapter 1: GENERAL DESCRIPTION
8.2. Paging Functions
8.2.1. Zone paging
Calls can be made to one of the pre-programmed zones. For PA paging, assign a PA paging output to the
zone number. For station paging, assign a station to the zone number. One of the following three settings can
be selected: PA paging only, station paging only, or a combination of PA paging and station paging. Use the
supplied N-8000 Software program to perform the mode setting. There are no limitations of the number of
stations that can be programmed nor the number of PA paging output.
8.2.2. Selectable paging
By performing dial operation at the station, paging can be made to up to 10 zones of the pre-programmed
multiple zones.
8.2.3. All-call paging
Calls can be made simultaneously to all of the pre-programmed zones.
Zone 1 Zone 2 Zone 3
8.3. Station Paging Receiving Mode
The station that receives Station Paging operates in either Conversation priority mode or Paging priority mode
as described below. However, when the exchange to which the station connects is the N-8010EX, the mode is
fixed to the Conversation priority mode.
Use the supplied N-8000 software for the mode setting.
8.3.1. Conversation priority mode
• When a paging is made, the station in standby mode receives it. If it is engaged in conversation or dialing, it
does not receive the paging.
• Even when a station is called while being paged, it continues to receive paging without being placed in
called status. In this case, the calling party hears a busy tone.
When a paging arises on a station being engaged in conversation and still continues after the conversation
is over, the station starts receiving the paging on completion of the conversation.
Note
Dialing is possible even while receiving a paging.
8.3.2. Paging priority mode
• When a page is made, the station in standby mode receives it. If paged during a conversation, the paged
station receives the page without terminating the current conversation, while a holding tone is transmitted to
the conversation partner during a conversation between paging and paged parties if the paging station does
not belong to the same paging zone.
• When the station being paged receives a call from another station, the paged station becomes busy and
maintains the paging. When the call to the station maintains after paging completion, the station receives the
call.
Note
Dialing is impossible while receiving a page. (Paging response cannot be performed at a paging receiving
station, either.)