Toa N-8000 Series Ver.1.41 - Manual (Page 216)

6-2
Chapter 6: SYSTEM SETTINGS USING THE BROWSER
1. OUTLINE OF SETTINGS USING BROWSER
Network settings can be updated and maintenance functions controlled by connecting to the exchange, multi
interface unit, or IP station via the PC's browser*. If an exchange, multi interface unit, or IP station is not within
range for the PC to administrate broadcast communications, use another PC to enable communications with
the exchange, multi interface unit, or IP station.
* Recommended Windows browser: Internet Explorer 6
Notes
• Not all settings can be performed via the browser. After updating the network settings, add the exchange or
multi interface unit manually using a PC installed with the N-8000 Software, then perform the required
settings. (refer to
p. 4-13 and p. 5-18 .)
• In the factory settings, the same IP address may be duplicated or the PC and the exchange, multi interface
unit, or IP station may not be set to the same network. When using the browser to perform network settings,
either connect only one exchange, multi interface unit, or IP station within the same network or disconnect
the equipment and the PC to be set from the network, and connect them directly using an Ethernet crossing
cable.
• CAUTION: If the power supply is shut off during setting change, this may cause a system failure.
• Updated settings become valid only after the equipment is restarted. Be sure to restart the equipment if
settings are changed. Conversations and paging currently in progress will be temporarily interrupted while
the equipment restarts.
2. MENU ITEMS
Note
Network Setting (refer to p. 6-5 )
Operation Status (refer to p. 6-6 )
Line Status (refer to p. 6-12 )
Network Status (refer to p. 6-14 )
Operation Log (refer to p. 6-15 )
Stream Log (refer to p. 6-17 )
System Management (refer to p. 6-20 )
Changes the IP address, subnet mask, and
default gateway of the exchange, multi interface
unit, or IP station connected to the PC.
Displays the connection status for all exchanges,
multi interface units, or IP stations within the
system.
Displays exchange, multi interface unit, or IP
station operation logs.
Used to change passwords and handle uploads
and downloads of settings files.
This menu is used to maintain exchanges, multi
interface units, or IP stations for which system
and function settings have been completed by
means of the N-8000 software.
Menu
Displays operation status.
Displays a log of the IP network's audio
communications.
This setting is applicable to the exchange only.
Displays the line status.