Audio i/o settings, P. 5-40, Be connected and cable length. (refer to – Toa N-8000 Series Ver.1.41 User Manual
Page 184: The connected equipment. (refer to, Refer to
5-40
Chapter 5: SYSTEM SETTINGS BY SOFTWARE
Chapter 5: SYSTEM SETTINGS BY SOFTWARE
Multi Interface: Audio I/O
5.5.4. Audio I/O settings
Step 1. Click on the Audio I/O tab.
The corresponding setting screen is displayed.
Step 2. Perform settings for each item of Audio I/O Ch 1 and Ch 2.
Set how to use the Multi-interface unit's Audio input and output terminals. The following setting items
are provided in Audio I/O Ch1 and Ch2.
(1) Input mode
Set the operation mode to be used.
If "Tie-line" or "PBX interface" is selected, the output mode is also automatically set to the same contents.
Tie-line:
Select this item when connecting the Multi interface unit to the exchange of different
series intercom system (EXES-2000 or EXES-6000 series system).
PBX I/F:
Select this item when connecting the Multi interface to the PBX analog E&M
interface.
Aux input paging: Select this item when connecting the Multi interface unit to playback components or
Remote microphone to make paging calls. Paging calls can be made to the
preprogrammed paging zones when the control input is activated.
BGM:
Select this item when broadcasting BGM to the stations in standby mode by
connecting playback components.
Unused:
The audio input is not used.