Toa N-8000 Series Ver.1.41 - Manual (Page 129)

3-33
Chapter 3: INSTALLATION & WIRING
Step 3. Tighten the terminal screws securely.
Notes
• Tug lightly on the cable to be sure that it does not pull free. If the cable pulls free, loosen the
terminal screw again and reconnect from Step 2.
• Use the screwdriver appropriate to the screws tightened into the terminal plug.
Step 4. (Removable terminal plug only)
Insert the wired terminal plug into the terminal block or the pin header.
Removable terminal plug
(supplied with the N-8000EX)
Removable terminal block
3
2
4
N-8000EX rear panel
Tighten
[N-8050DS]
Tighten
Terminal screw
Terminal block
Cable
3
2
Removable terminal plug
(supllied with the N-8031MS)
Pin header
Cable
[N-8031MS]
3
4
2
Tighten
1 2
N-8031MS's PC board
[N-8000EX]
Note: This terminal connection method also applies to the N-8000MI.
Note
This terminal connection method also applies to
the N-8540DS.