Toa N-8000 Series Ver.1.41 - Manual (Page 55)

2-3
Chapter 2: FUNCTIONS AND OPERATION
The calling station's internal speaker sounds an audible call tone.
• If the door station is not set to door station mode, a busy tone is heard
when the called master station is busy. When a busy tone is heard, wait till
the line becomes free, and you are automatically connected to the called
party.
[When the door station is set to door station mode]
The call tone sounds only once regardless of the called station's connection
mode settings.
When no response is made to a call within 30 seconds, the call
automatically stops, as the call timeout is limited to 30 seconds in this mode.
[When the door station is not set to door station mode]
When the called master station is set to Automatic connection mode, the
calling party is automatically connected after a brief tone and conversation
can begin.
When the called master station is set to Continuous call tone mode, a
continuous call tone sounds until the called station responds, after which
conversation can begin.
Note
Calls cannot be terminated at the door station.
Step 2. Conversation can begin when the called party responds.
[When the door station is set to door station mode]
Conversation automatically terminates in 30 seconds, as the conversation
timeout is limited to 30 seconds.
Tip
This 30-second limit becomes invalid when lifting the handset, or pressing
the hold key or transfer key at the master station.
[When the door station is not set to door station mode]
Conversations are available until the called party at the master station
executes the termination operation.
Note
Conversation cannot be terminated at the door station.
Notes
• Preprogram the master station to call to.
Programming can be performed by dialing operation of the multifunctional master station (refer to p.7-7 ) or
using the supplied N-8000 Software program (refer to p.5-54, 5-59 ).
• Use the supplied N-8000 Software program to perform Door station mode setting. (Refer to p.5-52, 5-56 .)
1.2. Calling from a Door Station
Step 1. Press the call button to call the pre-programmed master station.
Call tone