Toa N-8000 Series Ver.1.41 - Manual (Page 165)

5-21
Chapter 5: SYSTEM SETTINGS BY SOFTWARE Chapter 5: SYSTEM SETTINGS BY SOFTWARE
General: Station Table
5.3.2. Station number and type settings
Step 1. Click "Station Table" tab to display the setting screen.
Step 2. Enter the station number digits starting from 2 through 6.
Step 3. Set each item as follows:
(1) Equipment No. (Can't be edited.)
Refers to the equipment number of the exchange to which stations are connected.
(2) Equipment name (Can't be edited.)
Refers to the name of the Exchange to which stations are connected.
(3) Line No. (Can't be edited.)
Refers to the number of the line to which stations are connected.
(4) Type
Allows the type of station to be selected. Setting contents change depending on the type of station
selected.
(5) Station No.
Refers to the station number used when making a call. Set the number with the same digit length (1 – 3
digits) as that in the Station Number Digit setting.
When the Multi interface unit uses an access number, station numbers of which first digits match with the
access number cannot be used. (When the access number is a 2-digit number, the same first 2 digits of
numbers cannot be used for station numbers.)
Example: When the access number is "10," "110" and "1100" can be used but "10," "100," "101," or "1000"
cannot be used for station numbers.
Note
If a duplicated station number is set, it is displayed in red.
In this case, reset the number to a different one.