Toa N-8000 Series Ver.1.41 - Manual (Page 56)

2-4
Chapter 2: FUNCTIONS AND OPERATION
1.4. Station Speaker Volume
The volume of the master station speaker can be preset (in five 3-decibel increments) using the supplied N-
8000 software program, however it can also be adjusted at the station.
• Pressing the [ ] key during conversation increases the volume.
• Pressing the [ ] key during conversation decreases the volume.
Note
The resulting volume level will be maintained even after conversation is
finished.
1.3. Receiving a Call
1.3.1. Receiving a call at the master station
Step 1. Responding to a Received Call.
1-1. If the called station is set to Automatic connection
mode*, the call tone sounds only once, after which the
calling party's voice is heard immediately through the
internal speaker. Respond by speaking into the station
microphone or the handset.
1-2. If the called station is set to Continuous call tone mode*,
press any key for hands-free conversation or lift the
handset for handset conversation.
Tip
If a headset is connected to the called station, the call
tone is also heard from the station speaker.
Lifting the handset creates a handset conversation.
Step 2. When conversation is finished, press the Clear key or
replace the handset.
* Use the supplied N-8000 Software program to perform
Automatic connection mode/Continuous call tone mode setting.
(Refer to
p.5-52, 5-56 .)
or
5
or
C
[Example]
Master station
1.3.2. Receiving a call at the door station
When receiving a call from the master station, the call tone sounds only once, after which the calling party's
voice is heard immediately through the internal speaker. Respond by speaking into the door station.
Conversation termination operation cannot be executed at the door station.
Conversation can be terminated by the termination operation at the master station or after the preset time
limit.