Toa N-8000 Series Ver.1.41 - Manual (Page 164)

5-20
Chapter 5: SYSTEM SETTINGS BY SOFTWARE Chapter 5: SYSTEM SETTINGS BY SOFTWARE
General: Equipment Registration
Step 3. Set the Equipment name, Model, IP Address, and Web Port.
These items can be set directly by clicking and editing the data in each cell, or by importing
equipment data detected using the Unit Scan/Network Setting function. Follow the below procedures
when importing data from the result of Unit Scan.
3-1. Select the model number on the Equipment registration screen ( p. 5-18 ).
3-2. Press [Import from scan result] to display the following dialog.
3-3. Select an import destination from [Equipment Registration], and select an import source from
[Equipment Table], then press the [import] button. This will cause the settings data for the detected
equipment to be copied to the equipment selected as the import destination.
Copy can also be achieved by drag-and-drop operation from [Equipment Table] to [Equipment
Registration].
Note
Be sure to match the model number of import source with that of import destination for selection.
3-4. Click [OK] to close the dialog and return the display to the previous edit screen.
Step 4. Change the WAN IP address and the WAN Web port as required by clicking and editing the contents
of each cell directly.