Toa N-8000 Series Ver.1.41 - Manual (Page 185)

5-41
Chapter 5: SYSTEM SETTINGS BY SOFTWARE Chapter 5: SYSTEM SETTINGS BY SOFTWARE
Multi Interface: Audio I/O
(2) Output mode
Setting "Input mode" to "Aux input paging," "BGM" or "Unused" permits "PA paging" to be selected.
Tie-line: Select this item when connecting the Multi interface unit to the exchange of different series
intercom system (EXES-2000 or EXES-6000 series system).
PBX I/F: Select this item when connecting the Multi interface unit to the PBX analog E&M interface.
PA paging: Select this item when connecting the amplifier, etc. for PA paging.
Unused: The audio output is not used.
(3) Input sensitivity
Setting "Input mode" to "Tie-line" or "PBX I/F" permits the input sensitivity to be set.
Set the sensitivity level in 4 increments of 1 – 4. "1" (default) is the minimum and "4" is maximum. (5 dB
per step)
(4) Access No.
Setting "Input mode" to "Tie-line" or "PBX I/F" permits the access number to be set. Set the access
number between 0 and 99 (single or double digit), which is used when the Multi interface unit is connected
to different series intercom system or when making calls to a PBX.
Note
When a single digit number is set for the access number, avoid using numbers that match the first 1 digit
of station numbers.
When a double digit number is set for the access number, avoid using numbers that match the first 2 digits
of station numbers.
(5) Paging No.
Setting "Input mode" to "Aux input paging" permits the paging zone to be set.
Enter the paging zone number.
(6) Output level
Setting "Input mode" to "Tie-line" or "PBX I/F" permits the output level to be set.
Set the sensitivity level in 4 increments of 1 – 4. "1" is the minimum and "4" (default) is maximum. (5 dB
per step)
(7) Line attr (Line attribute)
Choose a line attribute from "PB," "DP10," and "DP20."
(8) Line start
Setting "Input mode" to "PBX I/F" permits the line start method to be set. Choose the line start method
from "Wink start," "Second dial tone," and "Timing start" signaling methods, which are defined as follows.
Wink start signaling method
After sending a start signal, a calling device sends a selective signal when it detects the
acknowledgment signal (140 to 290 ms contact-closure pulse) from the called device.
Second dial tone signaling method
After sending a start signal, a calling device sends a selective signal when it detects the dial tone from
the called device.
Timing start signaling method
After sending a start signal, a calling device sends a selective signal after 3 seconds have passed.