Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 175)

V T 1 0 0 I n t e r f a c e 4-59
OSPF Auth Key When configured, this parameter allows an authentication procedure to be
executed on the OSPF header. If the 64-bit (8 character) password does not
correspond, the packet is thrown away.
Values: 64 bits (8 characters)
Default: 8 spaces (no authentication)
Static Route Table Screen
Under some circumstances, it may not be necessary for a router to learn a
route using ordinary means such as RIP or OSPF. It is possible under these
circumstances for you to add a route to the route table of a router. The Static
Route menus are always associated with a circuit.
Figure 4.49 Static Route Table Screen
The fields on this screen are described below.
Routes Details Screen
This screen displays the details associated with a specific route.
Field Description
Endpoint Endpoint name (or interface) through which to send the IP packet
to reach the Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the target network.
Next Hop IP address of the next device in the route.
Cost Cost of using that route.
Rte Stat Indicates whether or not a route is enabled or disabled.