Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 47)

W e b S e r v e r I n t e r f a c e 3-17
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Supervisory interface screen.
DTR Alarm Control and Status Table
In addition to the configurable fields, the Supervisory screen displays a table
that lets you set the Data Terminal Ready (DTR) Alarm Control parameters
and view the current DTR Alarm Status.
Choices for DTR Alarm Control are “Enable” and “Disable”; the default
setting is “Disable.” Setting DTR Alarm Control to “Enable” allows the unit
to go into alarm on a loss of DTR, which occurs when the Supervisory port
detects that the DTR signal is low. The DTR Status field indicates the current
state of the DTR alarm.
Services Screen
The Services screen (Figure 3.12) displays the unit’s defined services and the
Interface, Type, and Pair parameters for each service.
Figure 3.12 Services Screen
The table in the center of the screen displays the available services listed by
index number. To view more detailed information about a service, click on the
index number associated with the desired service on the above screen and
then click on one of the user-activated “Details” buttons on the Service
Details screen as described below. A “Refresh” button is also provided on the
Services screen.
NOTICE: Any changes to settings in the Service Table require a “Save and
Restart” for them to take effect.
Adding a Service
To add a service, begin by clicking the “Add Service” button on the Services
screen. A new service listed by the next incremental index number will appear