Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 22)

1-8 W A N s u i t e 5 2 6 0 / 5 2 3 0
The front panel LED status indicators are defined below:
Indicator Description
NET This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when the E1 link is down.
The indicator lights amber when the E1 link is up and at least
one configured protocol is not established.
The indicator lights green when the E1 link is up and all
configured protocols are established.
NOTE: TDM is considered a protocol. It is established
whenever the E1 link is up.
SERIAL #1 Port in DTE Mode:
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when DSR is not active and the
configured protocol is not established.
The indicator lights amber when DSR is not active or the
configured protocol is not established.
The indicator lights green when DSR is active and the
configured protocol is established.
DTR Alarm Enabled (Port in DCE Mode):
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when DTR is not active and the
configured protocol is not established.
The indicator lights amber when DTR is not active or the
configured protocol is not established.
The indicator lights green when DTR is active and the
configured protocol is established.
DTR Alarm Disabled (Port in DCE Mode):
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights green when the configured protocol is
established.
The indicator lights red when the configured protocol is not
established.
SERIAL #2
(5260 Only) (Same as SERIAL #1 )
ALARM
(5230 Only) This indicator lights red if an alarm condition exists.
The indicator lights amber if a “yellow” alarm condition
exists.
POWER This indicator lights green when power is applied to the unit.
The indicator lights amber in test modes (Port looped or BERT
active).