Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 69)

W e b S e r v e r I n t e r f a c e 3-39
WANsuite 5260/5230 unit here. This DLCI can be used for management only,
or for management and actual data.
If this parameter is set, a PC connected to the LAN interface of this
WANsuite 5260/5230 can reach a remote WANsuite 5260/5230 through this
DLCI. The remote IP address must be part of an IP network that is different
from the local WANsuite 5260/5230, and the local WANsuite 5260/5230's IP
address must be configured into the PC. This way, local and remote
WANsuite 5260/5230s can be reached regardless of the availability of the
routers connected at the back of the WANsuite 5260/5230s.
Values: IP address
Default: 0.0.0.0
Remote IP Mask If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type If data received from this DLCI has to be switched to its corresponding
destination port, you must set the type to “Switched.” Set the type to “Local”
if this DLCI will be used for management purposes only.
Values: Switched, Local
Default: Switched
Endpoint Service Details Screen
Clicking the “Endpoint Service Details” button at the bottom of the Endpoint
Table screen displays the typical Service Details screen. Refer to Service
Details Screen on page 3-18 for a complete description of this type of screen.
DLCI Details Screen
The DLCI Details screen (Figure 3.32) lets you access the configuration
parameters described in the following paragraphs. To bring up this screen,
click the “Endpoint DLCI Details” button on the Endpoint Table screen or the
“DLCI Details” button on the Endpoint Details screen.