Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 34)

3-4 W A N s u i t e 5 2 6 0 / 5 2 3 0
Maintenance Reset Use this button to access a screen where you can perform a Maintenance
Reset (Figure 3.2). When you click on the arrow in the pull-down menu box
on the screen, you will have the option to perform a TDM, Packet, Packet 3,
or Packet 4 reset. When you select one of these options, all previous
configurations will be lost and the unit will be set back to the specified
factory default.
Figure 3.2 Maintenance Reset Screen
NOTICE: Performing a “Maintenance Reset” or a “Save and Restart” will
terminate communications with the unit. A “Refresh” should be
performed after approximately 10 seconds to restore communications.
Save and Restart Use this button to save the current configuration settings and proceed with the
restart as shown in Figure 3.3.
Figure 3.3 Save and Restart Confirmation Screen
Save and Restart Saves the current configuration and restarts.
Refresh Refreshes data on the current page.
Button Function