Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 90)

3-60 W A N s u i t e 5 2 6 0 / 5 2 3 0
Static Routes Screen
Under some circumstances, it may not be necessary for a router to learn a
route using ordinary means such as RIP or OSPF. It is possible under these
circumstances for you to add a route to the route table of a router.
The Static Routes menu is always associated with a circuit. Access this menu
by selecting the Static Routes Table from the RIP Parameters Table on the IP
Gateway menu.
Figure 3.47 Static Routes Screen
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the target network.
Next Hop IP address of the next device in the route.
Cost Cost of using that route.
Route Status Indicates whether a route is enabled or disabled.
The Static Routes Table screen provides the following user-activated buttons:
Route Details Screen
Access this menu by selecting “Route Details” from the Static Route menu.
Button Function
Route Details Displays the static route parameters.
Dynamic Route Table Displays routes learned via RIP or OSPF.
Add New Adds a new static route.
Refresh Refreshes data on the current page.