Appendix a specifications, Network 1 (5260) or network (5230) interface, Network 2 interface (5260 only) – Verilink WANsuite 5230 (34-00304.F) Product Manual User Manual
Page 219: Appendix a, specifications, Pecifications
S p e c i f i c a t i o n s
A-1
A
P P E N D I X
A
A
PPENDIX
A
S
PECIFICATIONS
Network 1 (5260) or Network (5230) Interface
Line Rate:
2.048 Mbps (
±
50 bps) unframed
Line Framing:
CAS, CCS, or 2 Mbits unframed
Line Code:
AMI or HDB3
Input Signal:
E1, +1 to
−
27 dB
Connection:
BNC jack at 75
Ω
(
±1
0 %), RJ-48 jack at 120
Ω
(
±1
0 %)
Output Signal:
3.0 V (
±
10 %) base -peak into 75 or 120
Ω
with protection
Transient Voltage:
1000 V protection, fused input / output
Jitter Control:
per G.823 Sections 2.1 and 3.0
Timing Source:
5260: With “Function” parameter on Network 2 screen in
Slave mode, options are Internal, Network 1, Network 2,
Serial 1, Serial 2
With “Function” parameter on Network 2 screen in Network
mode, options are Internal, Network 1, Serial 1
5230: Internal, Network, Serial
Ones Density:
HDB3, alternate fill; complies with G.701 and G.703
Network 2 Interface (5260 Only)
Line Rate:
2.048 Mbps (
±
50 bps) unframed
Line Framing:
CAS, CCS, or 2 Mbits unframed
Line Code:
AMI or HDB3
Input Signal:
E1, +1 to
−
27 dB (ALBO)
Connection:
BNC jack at 75
Ω
(
±1
0 %), RJ48 jack at 120
Ω
(
±1
0 %)
Output Signal:
3.0 V (
±
10 %) base -peak into 75 or 120
Ω
with protection
Transient Voltage:
1000 V protection, fused input / output
Jitter Control:
per G.823 Sections 2.1 and 3.0
Timing Source:
With “Function” parameter in Slave mode, timing parameter
is ignored
With “Function” parameter in Network mode, options are
Internal, Network 2, Serial 2
Ones Density:
HDB3, alternate fill; complies with G.701 and G.703