Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 212)

5-16 W A N s u i t e 5 2 6 0 / 5 2 3 0
Figure 5.16 Serial 1 and Serial Interface 2 (5260) or Serial (5230)
Configuration Menu Tree
Type Selects the type of interface (based on its electrical signal characteristics) used
by the equipment connected to the Serial port.
Values: X.21, V.35, RS-232, EIA-530
Default:V.35
NOTICE: V.35 requires the use of an optional cable. Refer to Optional Equipment
on page A-6 for ordering information.
Mode By default, the Serial port serves as a DCE port in both Packet and TDM
modes. However, the Serial port can serve as a DTE port when the unit is in
Packet mode.
If the Serial port connects to a DTE device (such as a FRAD or a router), you
must set this Mode parameter to “DCE.” If this port connects to a DCE device
(such as a DSU/CSU), you must set this Mode parameter to “DTE” (valid
only for Packet mode, not TDM).
Values: DCE, DTE
Default:DCE
NOTICE: DTE mode requires the use of an optional DTE cable. Refer to
Appendix A for ordering information.
X.21
V.35
RS-232
EIA-530
Serial 2
Config
Type Mode DSR DCD CTS RTS RTS Dly Tx Clock
DCE
DTE True
False
Int
True
False
Int
True
False
Int
Normal
True
Normal
Long
Int
Ext
Ch Rate Rate Inv Clock Bundling Start Ch # of Ch V.54 LL
DTR
Ctrl
Nx64K
Nx56K Cont
Alt
1–31 1–31 Dis
En
Dis
En
Dis
En
Dis
En
Serial 1
Config
Nx64K
Nx56K
(N = 1–32)