Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 211)

F r o n t P a n e l L C D I n t e r f a c e 5-15
Figure 5.15 Network 2 Configuration Menu Tree
Coding Sets the DSX port line coding.
Values: HDB3, AMI
Default:HDB3
CRC4 Mode Provides line integrity detection to determine if bit errors are present on the
line.
Values: Disable, Enable
Default:Disable
Channel Map Menu The CHANNEL MAP menu allows channels to be allocated/unallocated to
the NET 2 interface. The values for this option are:
• Idle
−
Channel not allocated
• Thru
−
Allocated to NET 2
• T+Sig
−
Allocate and Signaling enabled
There is no default value for this option.
Serial 1 and Serial 2 (5260) or Serial (5230) Configuration
Menus
Use the SERIAL 1 CONFIG and SERIAL 2 CONFIG on the WANsuite 5260
and SERIAL CONFIG on the WANsuite 5230 to set the configuration
parameters defined in the following paragraphs. The submenus and options
are the same for both SERIAL 1 CONFIG and SERIAL 2 CONFIG menus on
the 5260 and the SERIAL CONFIG menu on the 5230.
Coding Channel Map
HDB3
AMI
Idle
Thru
T+Sig
Channel 1
Channel 31
Idle
Thru
T+Sig
Net 2
Config
CRC4 Mode
Dis
En