Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 192)

4-76 W A N s u i t e 5 2 6 0 / 5 2 3 0
DHCP Server Details Screen
The DHCP Server Details screen (Figure 4.70) lets you configure the
parameters described below.
Figure 4.70 DHCP Server Details Screen
Enable Enables or disables the DHCP Server. Default is “Disable.”
Number of Ports Defines the number of DHCP ports to be used. In this version, only “1” is a
valid value.
TTL Time to Live for any DHCP packet. Default is 64.
Service Type Type of Service used by the DHCP Server packet. Default is 1.
Lease Time Tells the DHCP client the number of seconds it can retain this IP address. The
client should make a new DHCP request within the specified amount of time
to ensure the IP address is not given to another PC. Default is 600 seconds.
Primary DNS IP Addr If requested by DHCP client, the client then uses this address to resolve
names of IP addresses. Default is 0.0.0.0.
Secondary DNS IP
Addr
If requested by DHCP client, the client then uses this secondary address to
resolve names of IP addresses. Default is 0.0.0.0.
Domain Name Domain name to be used by all DHCP clients. Default is user’s server.
Router IP Addr IP address that all clients use for Gateway or Router. Default is 0.0.0.0.
Primary WINS IP
Addr
If requested by DHCP client, the client then uses this address to resolve
names of IP addresses. Default is 0.0.0.0.
Secondary WINS IP
Addr
If requested by DHCP client, the client then uses this secondary address to
resolve names of IP addresses. Default is 0.0.0.0.