Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 191)

V T 1 0 0 I n t e r f a c e 4-75
Server Address IP Address of the local UDP Server. Default is 0.0.0.0.
The “Add New” prompt lets the user add additional addresses.
You can configure or change the above-listed parameters on the Static UDP
Trans Details screen (Figure 4.69), which is accessed by selecting the
appropriate <Ndx> number on the Static UDP Trans Table screen.
Figure 4.69 Static UDP Translation Details Screen
Dynamic Host Configuration Protocol (DHCP)
DHCP provides a mechanism through which computers using TCP/IP can
obtain protocol configuration parameters automatically through the network.
The most important configuration parameter associated with DHCP is the IP
address. A computer must initially be assigned a specific IP address that is
appropriate to the network to which the computer is attached, and that is not
assigned to any other computer on that network. If a computer moves to a
new network, it must be assigned a new IP address for that new network.
DHCP can be used to manage these assignments automatically.
DHCP has other important configuration parameters also, such as the subnet
mask, default router, and Domain Name System (DNS) server. Using DHCP, a
network administrator can avoid “hands-on” configuration of individual
computers through complex and confusing setup applications. Instead, those
computers can obtain all required configuration parameters automatically,
without manual intervention, from a centrally managed DHCP server. DHCP
is available on the 10/100 Ethernet port only.
NOTICE: You must Save and Restart for any changes in DHCP configuration
parameters to take effect.
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.