Verilink WANsuite 5230 (34-00304.F) Product Manual - Manual (Page 187)

V T 1 0 0 I n t e r f a c e 4-71
Static TCP Trans Table Screen
The Static TCP Trans Table screen (Figure 4.63) allows static mapping of
global TCP Server ports to a local host IP address/port combination. The
parameters described below enable access to TCP servers on the private/
corporate network “behind the NAT.” The parameters may be used only when
in NAPT mode.
Figure 4.63 Static TCP Translation Table Screen
Global Port Decimal IP Port exposed to the global Internet. Default is 0.
Server Port Decimal IP Port of the local TCP Server. This port is usually the same as the
Global Port. Default is 0.
Server Address IP Address of the local TCP Server. Default is 0.0.0.0.
The “Add New” prompt lets the user add additional addresses.
You can configure or change the above-listed parameters on the Static TCP
Trans Details screen (Figure 4.64), which is accessed by selecting the
appropriate <Ndx> number on the Static TCP Trans Table screen.
NAT Ports Defines NAT global/Internet and local/corporate
ports.
Static UDP Translation Table Allows static mapping of global UDP Server ports to
a local host IP address/port combination.
Prompt Function