Wavetronix SmartSensor Advance Extended Range (SS-200E) - User Guide - Manual (Page 102)

CHAPTER 8 • VERIFY CHANNELS-ALERTS-ZONES 101
Qualified Count
When the Channel LED is activated in the right sidebar, the Qualified Count value will
always be displayed as “---” because a channel may consist of up to 16 zones and the exact
meaning of a channel’s Qualified Count is undefined.
When using the Qualified Count display mode, the first number on the tracker represents
the number of qualified detections in the zone and the number in parentheses represents
the amount of trackers needed to meet the defined requirements. If the number of qualified
detections is below the Qualified Count minimum, the number in parentheses is preceded
by a “-”; if the number of qualified detections is higher than the Qualified Count maximum,
the number in parentheses is preceded by a “+”; if the number of qualified detections is in
between the Qualified Count minimum and maximum settings, a “0” is displayed.
Figure 8.14 describes the numbers displayed when the qualified count is lower than, within
the limits of, or higher than the specified settings.
Detected
Qualified Count
Qualified Count
Minimum
Qualified Count
Maximum
Displayed Text
1 2 4 01 (-01)
3 2 4 03 (00)
6 2 4 06 (+02)
Figure 8.14 – Display Text for Qualified Count Zone Types
Note
When the selected roadway display mode shows the qualified count value on the
detection, the tracker highlighting indicates whether the specific detection meets
the range, speed, ETA, and priority level qualifications of the associated zone. High-
lighting on an individual tracker does not indicate whether or not there are enough
qualified detections to satisfy the qualified count filter for the zone.