Wavetronix SmartSensor Advance Extended Range (SS-200E) - User Guide - Manual (Page 111)

110 CHAPTER 9 • SETUP OUTPUT COMMUNICATIONS
Primary Push Manager
In standard installations the primary data push manager is used to send real-time detec-
tion information to the traffic controller on Port 2. (Port 2 is designated as the data bus.)
By default, the real-time detection information is sent every 0.13 seconds in the Z4 – Click
104/112/114 format.
This section describes the four settings contained in the top section of the Output Com-
munication Setup screen.
Select port to transmit output
This control allows you to manually select which of the SmartSensor Advance’s communi-
cation ports will be used for data pushing. The available options are None, Port 1 and Port
2.
In standard installations, Port 2 is an RS-485 port and is designated as the data bus. Data
push will automatically be set up when you auto-configure a contact closure card (Click
models 100/112/114/172/174). With version 3.0.2 and later, the default port is set at 2 and
the default format is Z4 - Click 112/114.
However, you do not have to use the default Port 2. If you select Port 1, be aware that in
standard installations, Port 1 is designated as the control bus. For SS200V sensors, the con-
trol bus is an RS-485 port usually connected to the bridge port of a Click 222 and is shared
with other devices.
The SmartSensor 6-conductor cable is used with SS200V sensors; the blue striped wires
are for Port 1 and the orange striped wires are for Port 2. However, remember that with the
original SS200 sensor or with the SS200VR (retrofit) sensor, port one is an RS-232 port.
Select the format of the output
This control allows you to manually select which type of data will be transmitted by Smart-
Sensor Advance. The options are:
˽ Z4 – Click 112/114
˽ Simple – Click 172/174 (not available for SmartSensor Advance Extended Range)
˽ Track File