TP-Link TL-WR902AC AC750 Wireless Dual-Band Travel Router - Manual (Page 38)

31
Chapter 4 Configure the Router in Wireless Router Mode
4. 3. Wireless
4. 3. 1. Basic Settings
1. Visit http://tplinkwifi.net , and log in with the username and password you set for the
router.
2. Go to Wireless 2.4GHz/5GHz > Basic Settings .
3. Configure the basic settings for the 2.4GHz/5GHz wireless network and click Save .
• Wireless Network Name - Enter a string of up to 32 characters. The default SSID is
TP-Link_XXXX (XXXX indicates the last unique four numbers of each router’s MAC
address). It is strongly recommended that you change your network name (SSID). This
value is case-sensitive. For example, TEST is NOT the same as test.
• Mode - Select the desired mode. It is strongly recommended that you keep the default
setting 11bgn mixed or 11a/n/ac mixed .
• Channel Width - Select any channel width from the drop-down list. The default setting
is Auto , which can automatically adjust the channel width for your clients.
• Channel - This field determines which operating frequency will be used. The default
channel is set to Auto . It is not necessary to change the wireless channel unless you
notice interference problems with another nearby access point.
• Enable SSID Broadcast - If enabled, the router will broadcast the wireless network
name (SSID).
4. 3. 2. WPS
WPS (Wi-Fi Protected Setup) can help you to quickly and securely connect to a network.
This section will guide you to add a new wireless device to your router’s network quickly
via WPS.
Note: The WPS function cannot be configured if the wireless function of the router is disabled. Please make sure the
wireless function is enabled before configuration.