TP-Link TL-WR902AC AC750 Wireless Dual-Band Travel Router - Manual (Page 97)

90
Chapter 5 Configure the Router in Access Point Mode
• Rate - The Throughput unit.
• Run Time - How long this function is running.
• Transmit - Wireless transmit rate information.
• Receive - Wireless receive rate information.
Click Start / Stop to start or stop wireless throughput monitor.
5. 5. DHCP
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of DHCP Server if necessary,
and you can reserve LAN IP addresses for specified client devices.
5. 5. 1. DHCP Settings
1. Visit http://tplinkwifi.net , and log in with the username and password you set for the
router.
2. Go to DHCP > DHCP Settings .
3. Specify DHCP server settings and click Save .