Riverstone Networks WICT1-12 - Manual (Page 168)

9-8 Riverstone Networks RS Switch Router User Guide Release 8.0
Example Configurations Packet-over-SONET Configuration Guide
The following is the configuration for router B:
9.6.3 PoS Link Between the RS and a Juniper Router
The following example shows a PoS link between an RS, router A, and a Juniper router, router B.
The following is the configuration for router A:
Note When you create an IP interface on the RS for a PoS link with a Juniper router,
you must specify the peer-address parameter. Otherwise, IP Control Protocol
(IPCP) negotiations will fail.
The following is the configuration for router B:
interface POS1/0
ip address 40.1.1.2 255.255.0.0
no ip directed-broadcast
encapsulation ppp
crc 32
pos scramble-atm
pos flag c2 22
interface create ip so-1 address-netmask 40.1.1.1/16 port so.6.1 peer-address
40.1.1.2
root# set interfaces so-0/1/0 unit 0 family inet address 40.1.1.2/16
root# set interfaces so-0/1/0 encapsulation ppp
root# set interfaces so-0/1/0 sonet-options fcs 32
Router
A
Router
B
so.6.1
so-1
40.1.1.1/16
so-0/1/0
40.1.1.2/16