Riverstone Networks WICT1-12 - Manual (Page 402)

17-94 Riverstone Networks RS Switch Router User Guide Release 8.0
Configuring L2 Tunnels MPLS Configuration
! Configure LDP peers and label bindings
ldp add interface lo0
ldp add remote-peer 111.1.1.1
adds R1 as LDP peer
ldp map ports gi.12.1 customer-id 10
maps port gi.12.1 to customer-id 10
ldp add l2-fec customer-id 10 vlan 100 to-peer 111.1.1.1
sends label mapping for customer-id
10/VLAN 100 to R1
ldp add l2-fec customer-id 10 vlan 200 to-peer 111.1.1.1
sends label mapping for customer-id
10/VLAN 200 to R1
ldp start
! Create the LDP-signaling VLAN and interface
vlan create ldp_in1 port-based id 120
vlan add ports gi.3.2 to ldp_in1
interface create ip to_r2 address-netmask 220.1.1.2/16 vlan ldp_in1
! If tunnel LSP uses RSVP:
mpls add interface to_r2
mpls start
rsvp add interface to_r2
rsvp start
! If tunnel LSP uses LDP:
mpls add interface to_r2
mpls start
ldp add interface to_r2
ldp start
! Configure IGP (in this example, OSPF is the IGP)
ip-router global set router-id 111.1.1.3
ospf create area backbone
ospf add interface to_r2 to-area backbone
ospf add stub-host 111.1.1.3 to-area backbone cost 5
ospf start