Riverstone Networks WICT1-12 - Manual (Page 416)

17-108 Riverstone Networks RS Switch Router User Guide Release 8.0
Traffic Engineering MPLS Configuration
On R1, the
mpls show label-switched-paths
command with the
verbose
option displays the selected path in
the
cspf-path
section (shown in bold in the example output below). Note that the hops are the interfaces where the
administrative group SKY is applied on the routers:
R1# mpls show label-switched-paths LSP1 verbose
Label-Switched-Path: LSP1
to: 3.3.3.3 from: 1.1.1.1
state: Up lsp-id: 0x8
proto: <rsvp> protection: none
setup-pri: 7 hold-pri: 0
attributes: <>
Path-Signalling-Parameters:
attributes: <>
inherited-attributes: <>
retry-limit: 1000 retry-int: 30 sec.
retry-count: 1000 next_retry_int: 60 sec.
bps: 0 preference: 7
hop-limit: 255 opt-int: 600 sec.
ott-index: 0 ref-count: 0
mtu: 0
cspf-path: num-hops: 3
hop: 94.9.9.10 - strict
hop: 94.9.9.11 - strict
hop: 201.135.89.195 - strict
include: sky
record-route:
94.9.9.10
94.9.9.11
201.135.89.195