Riverstone Networks WICT1-12 - Manual (Page 674)

30-70 Riverstone Networks RS Switch Router User Guide Release 8.0
Scenarios for Deploying Channelized T1, E1 and T3 WAN Configuration
Internet Service Provider B RS 32000 Configuration
The following configuration applies to the RS 32000 router at Internet Service Provider B.
!-----------------------------------------------------------------------------
!Configuration for the RS 32000 Channelized T3 interface
!-----------------------------------------------------------------------------
port set t3.4.1 cablelength 250
!-----------------------------------------------------------------------------
!Configure the T1 lines on the Channelized T3 interface
!-----------------------------------------------------------------------------
port set t3.4.1:(1-4) timeslots 1-24 wan-encapsulation ppp
port set t3.4.1:(5-8) timeslots 1-24 wan-encapsulation ppp
port set t3.4.1:(13-16) timeslots 1-24 wan-encapsulation ppp
port set t3.4.1:(17-20) timeslots 1-24 wan-encapsulation ppp
!-----------------------------------------------------------------------------
!Configure 2 multilink PPP bundles each containing 4 consecutive
!T1 lines
!-----------------------------------------------------------------------------
ppp create-mlp mp.1 slot 4
ppp add-to-mlp mp.1 port t3.4.1:(1-4)
ppp create-mlp mp.2 slot 4
ppp add-to-mlp mp.2 port t3.4.1:(5-8)
ppp create-mlp mp.3 slot 4
ppp add-to-mlp mp.3 port t3.4.1:(13-16)
ppp create-mlp mp.4 slot 4
ppp add-to-mlp mp.4 port t3.4.1:(17-20)
interface create ip to_cp1 address-netmask 110.25.30.6/24 port mp.1 up
interface create ip to_cp2 address-netmask 110.25.31.7/24 port mp.2 up
interface create ip to_asp1 address-netmask 130.65.20.9/24 port mp.3 up
interface create ip to_asp2 address-netmask 130.65.21.10/24 port mp.4 up
!-----------------------------------------------------------------------------
!Configure RIP:
!-----------------------------------------------------------------------------
rip add interface to_cp1
rip add interface to_cp2
rip add interface to_asp1
rip add interface to_asp2
rip start