Riverstone Networks WICT1-12 - Manual (Page 681)

Riverstone Networks RS Switch Router User Guide Release 8.0 30-77
WAN Configuration Scenarios for Deploying Channelized T1, E1 and T3
Figure 30-11 shows the network layout for this scenario. The tables following the figure show the commands used to
configure the interfaces for the routers at the various locations. Only the configurations of the Channelized T1 and E1
interfaces on each router are described.
Hardware Requirements
Figure 30-11 Transatlantic Connection Using a T1 and E1 Link
RS 8600 Configuration (USA)
The following configuration applies to the RS 8600 router.
Router Hardware Requirements
RS 8600 (USA) 1 Multi-Rate WAN module with 1 T1 WIC.
RS 8000 (Europe) 1 Multi-Rate WAN module with 1 E1 WIC.
!-----------------------------------------------------------------------------
!Configuration for the RS 8600 T1 interface
!-----------------------------------------------------------------------------
!T1 interface to Europe:
!(speed-56 is used because the local loop does not support B8ZS)
!-----------------------------------------------------------------------------
port set t1.2.1 framing sf
port set t1.2.1:1 timeslots 1-24 speed-56 wan-encapsulation ppp
interface create ip to_europe address-netmask 120.210.23.18/24 port t1.2.1 up
!-----------------------------------------------------------------------------
!Configure RIP:
!-----------------------------------------------------------------------------
rip add interface to_europe
rip start
US
Telco
European
Telco
T1
RS 8600
RS 8000
E1