Riverstone Networks WICT1-12 - Manual (Page 207)

Riverstone Networks RS Switch Router User Guide Release 8.0 12-11
VRRP Configuration Guide Monitoring VRRP
12.3.1 ip-redundancy trace
The
ip-redundancy trace
command is used for troubleshooting purposes. This command causes messages to be
displayed when certain VRRP events occur on the RS. To trace VRRP events, enter the following commands in Enable
mode:
12.3.2 ip-redundancy show
The
ip-redundancy show
command reports information about a VRRP configuration.
Display a message when any VRRP
event occurs. (Disabled by default.)
ip-redundancy trace vrrp events enabled
Display a message when a VRRP
router changes from one state to
another; for example Backup to
Master. (Enabled by default.)
ip-redundancy trace vrrp state-transitions
enabled
Display a message when a VRRP
packet error is detected. (Enabled by
default.)
ip-redundancy trace vrrp packet-errors
enabled
Enable all VRRP tracing.
ip-redundancy trace vrrp all enabled