Riverstone Networks WICT1-12 - Manual (Page 637)

Riverstone Networks RS Switch Router User Guide Release 8.0 30-33
WAN Configuration Channelized T1, E1 and T3 Services Overview
Configuring a Channelized T1 Interface
The following commands are an example of configuring a basic Channelized T1 interface.
For the Channelized T1 interface example:
•
port set t1.2.(1-4):1
- Configures the following parameters for ports 1 through 4.
•
framing esf
- Sets the framing type to Extended Super Frame.
•
fdl ansi
- Sets the Facilities Data Link (data channel) to ANSI.
•
lbo -7.5db
- Sets the line loss to -7.5 db.
•
timeslots 1-24
- Sets the range of time slots to select in a frame from 1 to 24.
•
wan-encapsulation ppp
- Sets the WAN encapsulation type to PPP. This must be specified on
the same line as the
timeslots
.
Configuring a Channelized E1 Interface
The following commands are an example of configuring a basic Channelized E1 interface.
For the Channelized E1 interface example:
•
port set e1.3.(1-4):1
- Configures the following parameters for ports 1 through 4.
•
framing crc4
- Sets the framing type to Cyclic Redundancy Check 4.
•
impedance 75ohm
- Sets the impedance of the line to 75 ohm.
•
timeslots 1-31
- Sets the range of time slots to select in a frame from 1 to 31.
•
ts16
- Sets timeslot 16 to be used for data. If timeslot 16 is used with other timeslots,
ts16
must
be specified on the same line as the
timeslots
.
•
wan-encapsulation ppp
- Sets the WAN encapsulation type to PPP. This must be specified on
the same line as the
timeslots
and
ts16
.
Configuring Channelized T3 Interfaces
The following commands are an example of configuring a basic Channelized T3 interface.
For the Channelized T3 interface example:
•
port set t3.4.1
- Configures the following parameter for the Channelized T3 interface on port 1.
•
lbo -7.5db
- Sets the Channelized T3 line loss to -7.5 db.
rs(config)# port set t1.2.(1-4) framing esf fdl ansi lbo -7.5db
rs(config)# port set t1.2.(1-4):1 timeslots 1-24 wan-encapsulation ppp
rs(config)# port set e1.2.(1-4) framing crc4 impedance 75ohm
rs(config)# port set e1.2.(1-4):1 timeslots 1-31 ts16 wan-encapsulation ppp
rs(config)# port set t3.4.1 lbo -7.5db