Riverstone Networks WICT1-12 - Manual (Page 696)

30-92 Riverstone Networks RS Switch Router User Guide Release 8.0
Scenarios for Deploying Clear Channel T3 and E3 WAN Configuration
Metropolitan Service Provider RS 8000 Configuration
The following configuration applies to the RS 8000 router at the Metropolitan Service Provider.
!-----------------------------------------------------------------------------
!Configuration for the RS 8000 Clear Channel T3 interfaces
!-----------------------------------------------------------------------------
port set t3.2.1 cablelength 200 wan-encapsulation ppp
interface create ip to_ispa address-netmask 135.22.34.2/24 port t3.2.1 up
port set t3.2.2 cablelength 200 wan-encapsulation ppp
interface create ip to_ispb address-netmask 155.15.5.2/24 port t3.2.2 up
!-----------------------------------------------------------------------------
!Configuration for the RS 8000 Channelized T3 interface
!-----------------------------------------------------------------------------
port set t3.4.1 cablelength 200
!-----------------------------------------------------------------------------
!Configure the T1 lines on the Channelized T3 interface
!-----------------------------------------------------------------------------
port set t3.4.1:(1-4) timeslots 1-24 wan-encapsulation ppp
port set t3.4.1:(9-12) timeslots 1-24 wan-encapsulation ppp
port set t3.4.1:13 timeslots 1-24 wan-encapsulation ppp
!-----------------------------------------------------------------------------
!Configure 2 multilink PPP bundles each containing 4 consecutive T1 lines
!-----------------------------------------------------------------------------
ppp create-mlp mp.1 slot 4
ppp add-to-mlp mp.1 port t3.4.1:(1-4)
ppp create-mlp mp.2 slot 4
ppp add-to-mlp mp.2 port t3.4.1:(9-12)
interface create ip to_hqsite address-netmask 120.210.11.1/24 port mp.1 up
interface create ip to_rsite_mppp address-netmask 120.210.12.1/24 port mp.2 up
interface create ip to_rsite_ft1 address-netmask 120.210.13.1/24 port t3.4.1:13 up
!-----------------------------------------------------------------------------
!Configure RIP:
!-----------------------------------------------------------------------------
rip add interface to_hqsite
rip add interface to_rsite_mppp
rip add interface to_rsite_ft1
rip add interface to_ispa
rip add interface to_ispb
rip start