Riverstone Networks WICT1-12 - Manual (Page 679)

Riverstone Networks RS Switch Router User Guide Release 8.0 30-75
WAN Configuration Scenarios for Deploying Channelized T1, E1 and T3
rsite2 RS 3000 Configuration
The following configuration applies to the RS 3000 router at the remote site, rsite2.
!-----------------------------------------------------------------------------
!Configuration for the RS 3000 E1 interfaces
!-----------------------------------------------------------------------------
!E1 interfaces to the ISP:
!-----------------------------------------------------------------------------
port set e1.2.1 framing crc4
port set e1.2.1:1 timeslots 1-31 wan-encapsulation ppp
port set e1.2.2 framing crc4
port set e1.2.2:1 timeslots 1-31 wan-encapsulation ppp
port set e1.2.3 framing crc4
port set e1.2.3:1 timeslots 1-31 wan-encapsulation ppp
port set e1.2.4 framing crc4
port set e1.2.4:1 timeslots 1-31 wan-encapsulation ppp
ppp create-mlp mp.1 slot 2
ppp add-to-mlp mp.1 port e1.2.(1-4):1
interface create ip to_isp address-netmask 120.210.2.2/24 port mp.1 up
!-----------------------------------------------------------------------------
!E1 interface to the hqsite:
!-----------------------------------------------------------------------------
port set e1.3.1 framing crc4
port set e1.3.1:1 timeslots 1-31 wan-encapsulation ppp
interface create ip to_hqsite address-netmask 120.210.12.1/24 port e1.3.1 up
!-----------------------------------------------------------------------------
!E1 interface to the rsite3:
!-----------------------------------------------------------------------------
port set e1.3.2 framing crc4
port set e1.3.2:1 timeslots 1-31 wan-encapsulation ppp
interface create ip to_rsite3 address-netmask 120.210.23.3/24 port e1.3.2 up
!-----------------------------------------------------------------------------
!Configure RIP:
!-----------------------------------------------------------------------------
rip add interface to_isp
rip add interface to_hqsite
rip add interface to_rsite3
rip start