Riverstone Networks WICT1-12 - Manual (Page 409)

Riverstone Networks RS Switch Router User Guide Release 8.0 17-101
MPLS Configuration Configuring L2 Tunnels
R6 is a transit LSR with interfaces to R1 and R5. The following is the configuration for R6:
ldp map ports gi.6.2 customer-id 20
map port gi.6.2 to customer-id 20
ldp add remote-peer 111.1.1.1
adds R1 as LDP peer
ldp add l2-fec customer-id 20 vlan 60 to-peer 111.1.1.1
sends label mapping for customer-id 20/VLAN
60 to R1
ldp start
! Configure VLANs and interfaces
vlan create ip_signal ip id 12
vlan add ports gi.4.1,gi.5.1 to ip_signal
interface create ip to_rs1 address-netmask 201.1.1.2/16 port gi.4.2
interface create ip to_rs5 address-netmask 220.1.1.1/16 vlan ip_signal
interface add ip lo0 address-netmask 111.1.1.6/32
! Configure OSPF
ip-router global set router-id 111.1.1.6
ospf create area backbone
ospf add interface all to-area backbone
ospf add stub-host 111.1.1.6 to-area backbone cost 5
ospf start
! Configure MPLS
mpls add interface to_rs1
mpls add interface to_rs5
mpls start
! Configure RSVP
rsvp add interface to_rs1
rsvp add interface to_rs5
rsvp start