Riverstone Networks WICT1-12 - Manual (Page 241)

Riverstone Networks RS Switch Router User Guide Release 8.0 15-7
IS-IS Configuration Guide Displaying IS-IS Information
In the example above, interfaces
gig1
through
gig3
will not forward an LSPs if the LSP is received by any interface
in mesh group 10. Additionally, interface
gig4
will not forward an LSP, regardless of the interface on which it is
received.
15.6 DISPLAYING IS-IS INFORMATION
The RS provides a number of commands which you can use to view information about your IS-IS configuration. The
isis show all
command displays all the router’s IS-IS tables. Individual tables may also be viewed using the
commands in the following table.
Note For additional information about the
isis show
commands, their parameters, or
the fields in the output, refer to the Riverstone RS Switch Router Command Line
Interface Reference Manual.
15.6.1 IS-IS Sample Configuration
Consider the following network configuration. The network shown consists of 11 routers subdivided into four IS-IS
areas.
Figure 15-1 shows the network topology. Figures 11 through 14 provide a detailed illustration of each area.
Displays IS-IS adjacencies.
isis show adjacencies [detail]
Displays information about the other
router on the circuit.
isis show circuits [detail]
Displays IS-IS export policies.
isis show export-policies
Displays IS-IS global parameters.
isis show globals
Displays Link State PDU (LSP)
database information.
isis show lsp-database level1|2
[detail][id
<string>
][summary]
Displays IS-IS timers.
isis show timers