Riverstone Networks WICT1-12 - Manual (Page 584)

27-2 Riverstone Networks RS Switch Router User Guide Release 8.0
Configuring the RS for Port Mirroring Performance Monitoring
27.1 CONFIGURING THE RS FOR PORT MIRRORING
The RS allows you to monitor activity with port mirroring. Port mirroring allows you to monitor the performance and
activities of ports on the RS or for traffic defined by an ACL through just a single, separate port. While in Configure
mode, you can configure your RS for port mirroring with a simple command line like the following:
Note Port mirroring is available for WAN ports. However, you cannot configure port
mirroring on a port-by-port basis. (You can only configure port mirroring for the
entire WAN card).
Only IP ACLs can be specified for port mirroring.
Show multicast statistics.
statistics show multicast
Show port error statistics. statistics show port-errors
Show potential physical layer errors.
statistics show phy-errors
Show port normal statistics.
statistics show port-stats
Show RMON etherStats statistics.
statistics show rmon
Show traffic summary statistics.
statistics show summary-stats
Show most active tasks.
statistics show top
Show TCP statistics.
statistics show tcp
Show UDP statistics.
statistics show udp
Show TACACS server statistics. tacacs show stats
Show broadcast monitoring information for ports.
port show bmon [config][detail][port
SRUW
OLVW!
][stats]
Show all VLANs.
vlan list
Configure port mirroring.
port mirroring monitor-port
<port number>
target-port
<port
list>|target-profile <acl name>