Riverstone Networks WICT1-12 - Manual (Page 82)

5-18 Riverstone Networks RS Switch Router User Guide Release 8.0
GARP/GVRP Bridging Configuration Guide
The following is the configuration for R1:
The following is the configuration for R4:
Note that because dynamic VLAN creation was enabled on R4, we did not have to manually configure any VLAN on
R4.
Create VLAN RED as a port-based VLAN and add ports to it.
vlan create red port-based
vlan add ports et.1.1-3 to vlan red
Enable GVRP
gvrp start
Enable GVRP on ports et.1.1-3.
gvrp enable ports et.1.1-3
Ports et.1.2 and 1.3 do not need to send GARP PDUs because they are connected to devices that are not running
GVRP. Therefore, we should set their status to non-participating.
gvrp set applicant status non-participant et.1.2-3
Create the SmartTRUNK.
smarttrunk create st.1 protocol no-protocol
Add ports to the SmartTRUNK.
smarttrunk add ports et.1.1-3 to st.1
Enable GVRP
gvrp start
Enable GVRP on ports st.1, and et.7.1-3.
gvrp enable ports st.1, et.7.1-3
Enable dynamic VLAN creation so when R1, R2, or R3 sends a request for a VLAN, it will dynamically be created
on R4.
gvrp enable dynamic vlan-creation