Riverstone Networks WICT1-12 - Manual (Page 229)

Riverstone Networks RS Switch Router User Guide Release 8.0 14-13
OSPF Configuration Guide Monitoring OSPF
Following is an example of the
ospf show statistics interface
command. It displays the number of each type
of LSA that was processed.
Following is an example of the
ospf show virtual-links
command:
rs# ospf show statistics interface 190.135.89.227
Statistics for Interface 190.135.89.227:
Packets Received:
Monitor 0 Hello 366
Database Desciption 4 LS Request 1
LS Update 14 LS Acknowledgement 3
Packets Sent:
Monitor 0 Hello 365
Database Desciption 3 LS Request 1
LS Update 3 LS Acknowledgement 14
Errors:
Packet too short 0
Invalid header lengh 0 Invalid version 0
Invalid checksum 0 Invalid authentication type 0
No such multicast interface 0 No such interface 0
Invalid interface 0 Invalid Mask 0
Invalid Hello interval 0 Invalid Router Dead interval 0
Unknown neighbour 0 Options mismatch 0
Master flag mismatch 0 Initialize flag mismatch 0
DD sequence number mismatch 0 Invalid LS type 0
Bad LS Request 0 No such virtual interface 0
Invalid area ID 0 Confusing Master/Initial flags 2
Invalid MD5 digest 0 Own packet received 0
Invalid authentication key 0 DD Options mismatch 0
Packet on passive interface 0 Packet on down virtual interface 0
Packet with same router id as ours 0
rs# ospf show virtual-links
Internet Address 2.2.2.2, Transit Area 201.135.89
Router ID 3.3.3.3, Network Type Virtual, Cost: 20
Transmit Delay is 1 sec, State Pt2Pt, Priority 1
Designated Router (ID) 0.0.0.0, Interface address 2.2.2.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 15:39:53
Neighbor Count is 1
Internet Address 4.4.4.4, Transit Area 201.135.89
Router ID 3.3.3.3, Network Type Virtual, Cost: 1
Transmit Delay is 1 sec, State Down, Priority 1
Designated Router (ID) 0.0.0.0, Interface address 4.4.4.4
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 0