Riverstone Networks WICT1-12 - Manual (Page 174)

10-4 Riverstone Networks RS Switch Router User Guide Release 8.0
Monitoring the DHCP Server DHCP Configuration Guide
To force the DHCP server to immediately update its lease database, enter the following command in Enable mode:
10.3 MONITORING THE DHCP SERVER
To display information from the lease database:
To display the number of allocated bindings for the DHCP server and the maximum number allowed::
10.4 DHCP CONFIGURATION EXAMPLES
The following configuration describes DHCP configuration for a simple network with just one interface on which
DHCP service is enabled to provide both dynamic and static IP addresses.
1. Create an IP VLAN called ‘client_vlan’.
2. Add all Fast Ethernet ports in the RS to the VLAN ‘client_vlan’.
3. Create an IP interface called ‘clients’ with the address 10.1.1.1 for the VLAN ‘client_vlan’.
Force the server to update its lease
database.
dhcp flush
Show lease database information.
dhcp show binding
[active|expired|static]
Show the number of allocated bindings
for the DHCP server.
dhcp show num-clients
vlan create client_vlan ip
vlan add port et.*.* to client_vlan
interface create ip clients address-netmask 10.1.1.1./16 vlan
client_vlan