Riverstone Networks WICT1-12 - Manual (Page 48)

3-6 Riverstone Networks RS Switch Router User Guide Release 8.0
Getting Help with CLI Commands CLI and RS Basics
3.5 GETTING HELP WITH CLI COMMANDS
Interactive help is available in the CLI. Invoke help by entering a question mark (
?
) character at any command prompt,
or after a keyword in any mode. Then press Enter. A set of facility names will display. These are the facilities and
commands that can be used in that particular mode. Following is an example of typing
?
at the enable prompt:
Invoking Help While Entering a Command
Type the
?
character after entering a command to see a list of the parameters or options to choose to use with that
command. Once the help information is displayed, the command is displayed as before but without the
?
character.
Following is an example of invoking help while entering a command:
rs> ?
aging - Show Aging information
cli - Modify the command line interface behavior
dvmrp - Show DVMRP related parameters
enable - Enable privileged user mode
exit - Exit current mode
file - File manipulation commands
help - Describe online help facility
igmp - Show IGMP related parameters
ip-redundancy - Show IP Redundancy information (VRRP)
ipx - Show IPX related parameters
l2-tables - Show L2 Tables information
logout - Log off the system
multicast - Show Multicast related parameters
ping - Ping utility
pvst - Show Per Vlan Spanning Tree Protocol (PVST)
parameters
sfs - Show SecureFast Switching (SFS) parameters
statistics - Show or clear router statistics
stp - Show Spanning Tree Protocol (STP) parameters
telnet - Telnet utility
traceroute - Traceroute utility
vlan - Show VLAN related parameters
rs(config)# load-balance create ?
group-name - Name of this Load Balanced group of servers
vip-range-name - Name of this Virtual IP range
rs(config)# load-balance create