Riverstone Networks WICT1-12 - Manual (Page 78)

5-14 Riverstone Networks RS Switch Router User Guide Release 8.0
Monitoring Bridging Bridging Configuration Guide
These filters allow or force traffic to go to a set of destination ports based on a frame's source MAC address,
destination MAC address, or both source and destination MAC addresses in flow bridging mode. Static entries are
always configured and applied at the input port.
• Secure port filters
A secure filter shuts down access to the RS based on MAC addresses. All packets received by a port are dropped.
When combined with static entries, however, these filters can be used to drop all received traffic but allow some
frames to go through.
5.10 MONITORING BRIDGING
The RS displays bridging statistics and configurations contained in the RS.
To display bridging information, enter the following commands in Enable mode.
Show IP routing table.
ip show routes
Show all MAC addresses currently in the
l2 tables.
l2-tables show all-macs
Show l2 table information on a specific
port.
l2-tables show port-macs
Show information the master MAC table.
l2-tables show mac-table-stats
Show information on a specific MAC
address.
l2-tables show mac
Show information on MACs registered.
l2-table show bridge-management
Show all VLANs.
vlan show