Riverstone Networks WICT1-12 - Manual (Page 414)

17-106 Riverstone Networks RS Switch Router User Guide Release 8.0
Traffic Engineering MPLS Configuration
The following is the configuration for R2:
! Configure LSP with admin-group constraint (do not specify no-cspf parameter)
mpls create label-switched-path LSP1 to 3.3.3.3 include sky
!Enable and start MPLS and RSVP
mpls add interface R1R2
mpls start
rsvp add interface R1R2
rsvp add interface R1R2b
rsvp start
! Create interfaces
interface create ip R2R1 address-netmask 16.128.11.7/24 port gi.6.2
interface create ip R2R1b address-netmask 94.9.9.11/24 port gi.5.1
interface create ip R2R3 address-netmask 201.135.89.197/26 port gi.4.1
interface add ip lo0 address-netmask 2.2.2.2/16
! Configure OSPF
ip-router global set router-id 2.2.2.2
ospf create area backbone
ospf add stub-host 2.2.2.2 to-area backbone cost 10
ospf add interface R2R1 to-area backbone
ospf add interface R2R1b to-area backbone
ospf add interface R2R3 to-area backbone
ospf set traffic-engineering on
Enable traffic engineering extensions for OSPF
ospf start
! Create and apply admin-group
mpls create admin-group sky group-value 7
mpls add interface R2R1
mpls add interface R2R1b
mpls add interface R2R3
mpls set interface R2R1b admin-group sky
mpls set interface R2R3 admin-group sky
! Enable and start MPLS and RSVP
mpls start
rsvp add interface R2R1
rsvp add interface R2R1b
rsvp add interface R2R3
rsvp start