9 creating an aggregate source, 10 import policies example: importing from rip, Creating an aggregate source -18 – Riverstone Networks WICT1-12 User Manual
Page 448: Import policies example: importing from rip -18
18-18 Riverstone Networks RS Switch Router User Guide Release 8.0
Configuring Advanced Routing Policies
Routing Policy Configuration
18.3.9
Creating an Aggregate Source
To create an aggregate source, enter the following command in Configure mode:
18.3.10
Import Policies Example: Importing from RIP
The importation of RIP routes may be controlled by any of protocol, source interface, or source gateway. If more than
one is specified, they are processed from most general (protocol) to most specific (gateway).
RIP does not support the use of preference to choose between routes of the same protocol. That is left to the protocol
metrics.
For all examples in this section, refer to the configuration shown in
.
Create an aggregate source.
ip-router policy create aggr-gen-source
<name>
protocol
<protocol-name>